removing drill motor chucks

[psycho_fling]

hi all

i have bought some new drill motors and for the first time ver i cannot remove the chucks off them the reverse screww came out fine but the chucks won't budge

anyone have any ideas?

i have tried to remove the outer plastic to get to the shafts to put some grips on then try it but still doesn't help

help???? :shock:

[widow_twanky]

Re: removing drill motor chucks

I usually just stick the short end of the biggest alan key I can find in the chuck, secure the body and then hit the long end with a hammer. Works sometimes and not at others.

Andy

[dgr]

Re: removing drill motor chucks

I had a very similar issue to this, are they the drills that Wilkinson sells by any chance? Sad to say I never managed to get the chuck off...

[RogueTwoRobots]

Re: removing drill motor chucks

Drill a hole through the chuck (obviously not with the drill you're trying to get the chuck off of ) and put a piece of bar or bolt through it, then bash it with a hammer? Make sure to bash rather than slowing turning it, more chance of the sudden impacts loosening things

[widow_twanky]

Re: removing drill motor chucks

Seems the theory 'if it doesnt work, hit it with a hammer' will work just nice for this one!!

[typhoon_driver]

Re: removing drill motor chucks

open the casing and put a flat headed screw driver into the holes in the motor to stop it turning. Put the whole assembly into a bench vice. Get a pair of mole grips, clamp onto the chuck and either using a hammer gently tap the mole grips until it comes loose.

Sounds like the glue on the inside of the chuck is decent compared to the crap thats normally thrown in.

[beast]

Re: removing drill motor chucks

yes just hit it with hammer it will come off

[psycho_fling]

Re: removing drill motor chucks

tried those methods but didnt work

so i had to resort to hacking the entire chuck plastic assembly, spring and bearing reatining plate off

this left a bear chuck and a shaft which would slide out the gear bx just a case then of getting good grip in vice and twisting with mole grips

before couldn't get any hold on the shaft

2hrs, 8 dremel discs anumber of scrapped knuckles and they are done

:twisted: