OrangeRX R620 + DX5e not failsafing properly

[Flag Captured]

I've just got through my Orange R620 today, and I've been having a few problems making it failsafe properly, namely one ESC being on full forward lock when it's supposed to failsafe, despite the sticks being in neutral when I was binding it. Have I got a dud, or is this just an issue with the Orange receivers?

Thanks for any help!

[Niels - Team K.a.L.M.]

What i did to get it bound with the desired failsafes. (dx5e and the orange r800x)
insert the bind plug, activate your tx while holding the trainer switch. activate the rx with the bind plug in it. give it a few seconds and than pull the bind plug. release the trainer switch and it should have bonded.

[Flag Captured]

I'll give that a try, thanks!
When I was setting it up, I didn't remove the bind until after, so that might be it. It's been pretty temperamental so far getting it to even connect up, but I guess it's either that or an expensive receiver I can't afford!