no toy robotics clear out (wotty fund)

[adz600]

hi all, many items below for sale any questions please ask, being as honest as possible on descriptions
all photos below, offers welcome

2xbosch 750w motors , have tested run in both directions, unsure on magnet mods etc, have been welded for sprocket and a cotter pin drill hole but would weld with ease £80 pair

2x36v 1kw scooter motors brand new, cost £ 90 each please see photos pair £100 includes 2 sets of sprockets different sizes

4 wheels and 4 8mm sprockets design to go with the scooter motors as a heavyweight drive setup £50

high flow sr310 co2 regulator tested ok £ ???

2xESC (NCC 70's and control board ) £ 60

go kart drive setup from jono not needed £40

[mrsam]

Don't suppose any of those sprockets in the bag are for 6mm chain? Also do they have a d shaped hole?

[blazerbotics]

I'll have the Boschs off you, might have the 4QDs as well.

[geeza]

I'll have the regulator, will pm you.

[plargen]

hi just wandering what the go kart wheel dimensions and the sprocket pitch is

and are you going colchester

[typhoon_driver]

Can't quite read the regulator specs, what's the max flow through it?

Edit- Just noticed Ed's post. If he hasn't taken it I will.

[adz600]

wheel info is

gokart wheels are10inch x 5inch
76 tooth sprocket, pitch just under 8mm so it must be imperial, standard gokart chain 35# I think

other wheels are 10inch x 3 inch foam filled

[plargen]

think i will go for the go kart drive

are you going to colchester or gsl

[adz600]

Boschs sold
go kart wheels sold
sr310 awating reply to pm

[adz600]

Sr310 reg sold,

4 x wheels have internal needle roller bearings and are split rims,
can be sold as a full hw drive setup with motors would just require chain,

this was my initial plan but no time or money left and space in garage required for my current house diy project