Tweet
Got a few more things up for sale- PM offers
First up is my Beetleweight- Built a while back and has not been used- needs rewiring. Includes
5mm HDPE chassis
2x 11:1 MFA motors with Custom wheels
Sabretooth 10A ESC
2, 2cell, 1000mAh Lipo packs
Spektrum AR6200 rx
Drum Spinner with large brushed motor on 1:1 ratio via timing belts
Blue speedo for drum
Designed to have interchangeable weapons so the drum can be removed using 4 screws
Spektrum DX5e Tx.
Several Antweight Shells
These include the 3D printed fleaweight shell and flipper arm from Shapeways- 2mm thick with mounting points for base plate.
Ant Awe 6 shell- used for a couple of years- some slight damage
Carbon fibre and Vacuum formed shell- based on Thor, never completed
Recoil- half finished fleaweight
3D printed chassis with carbon fibre shell
Flipper servo, voltage regulator and Lipo- no rx or drive servos
Lots of ant parts including
2x 50:1 HP pololu motors with wheels attached
1x Peter Waller option D speed controller
1x Technobots Z48 controller with RC lead- never used
1x Parkflyer HPXF servo
1x Aluminum drum- for 18mm outrunner motor- no teeth
1x 6ch 40MHz rx
1x 5g micro servo
1x Brushed single channel single direction ESC
2x 9g 360 degree modded speed hacked servos
2x 6g 360 degree modded speed hacked servos
1x 6v park BEC
Next load of Parts will be featherweight bits including a LP pneumatics setup
First up is my Beetleweight- Built a while back and has not been used- needs rewiring. Includes
5mm HDPE chassis
2x 11:1 MFA motors with Custom wheels
Sabretooth 10A ESC
2, 2cell, 1000mAh Lipo packs
Spektrum AR6200 rx
Drum Spinner with large brushed motor on 1:1 ratio via timing belts
Blue speedo for drum
Designed to have interchangeable weapons so the drum can be removed using 4 screws
Spektrum DX5e Tx.
Several Antweight Shells
These include the 3D printed fleaweight shell and flipper arm from Shapeways- 2mm thick with mounting points for base plate.
Ant Awe 6 shell- used for a couple of years- some slight damage
Carbon fibre and Vacuum formed shell- based on Thor, never completed
Recoil- half finished fleaweight
3D printed chassis with carbon fibre shell
Flipper servo, voltage regulator and Lipo- no rx or drive servos
Lots of ant parts including
2x 50:1 HP pololu motors with wheels attached
1x Peter Waller option D speed controller
1x Technobots Z48 controller with RC lead- never used
1x Parkflyer HPXF servo
1x Aluminum drum- for 18mm outrunner motor- no teeth
1x 6ch 40MHz rx
1x 5g micro servo
1x Brushed single channel single direction ESC
2x 9g 360 degree modded speed hacked servos
2x 6g 360 degree modded speed hacked servos
1x 6v park BEC
Next load of Parts will be featherweight bits including a LP pneumatics setup
Comment