Vapourbot Images...

[majinb]

Vapourbot Images...

Been asked by Kody to do Isolation Joey, but first I want to know for sure wheter the version seen here

http://strickenone.proboards99.com/index.cgi?board=chevhw&action=display&thread=206http://strickenone.proboards99.com/i...isplay&thread= 206

is the final version you want. Kody showed me a mail you send him in which the dimensions were different than the ones shown in the stats.

[joey_picus]

Vapourbot Images...

Yeah, thats it - the original dimensions were messed up a bit. I send Kody a bad Paint picture as well giving a few details, did you get that?

(I feel like Im causing everyone problems now :P)

[majinb]

Vapourbot Images...

what I got from Kody through msn was 105 x 100 x 50 cms

what I get from the Zlayers/VED forum is 105 x 105 x 45 cm

what should I go with, and could you please edit the stats on the forum so I can see the final version?

[joey_picus]

Vapourbot Images...

Uh...dont know...probably 105 x 105 x 50 including the disc and upward bars, and 105 x 105 x 45 without said things...

[majinb]

Vapourbot Images...

you 100% sure you want me to go with the stats on the forum atm?:P

[kodster]

Vapourbot Images...

Joey, I thought the disc and flipper didnt reach up above the wedge :S

[joey_picus]

Vapourbot Images...

Guys, if its causing this many problems Id prefer there not to be a CAD at all, I could do without the stress - but the way I see it is the disc does go above the wedge, but the flipper bars go slightly further above and stop the disc hitting the ground when inverted. It should be in the pic here:
http://i267.photobucket.com/albums/ii302/joeychevron/isolationhowiseeitmoreorless.pnghttp://i267.photobucket.com/albums/i...seeitmoreorles s.png

[majinb]

Vapourbot Images...

no stress, if you 100% sure the stats on the forums are right now then Ill do the CAD

[joey_picus]

Vapourbot Images...

95% sure, if they result in a slightly off CAD Ill probably modify them to fit so meh.

[majinb]

Vapourbot Images...

Joey, I wanna know if the shape so far is good

especially the fact that the tubes you see (they wont be in the eventual CAD) are closer to each other on the top than at the bottom, is it supposed to be like that or are the tubes supposed to be parallel?

http://i74.photobucket.com/albums/i268/_MadBull_/iso1.jpghttp://i74.photobucket.com/albums/i2...Bull_/iso1.jpg

[majinb]

Vapourbot Images...

and dont feel guilty if youd say you want the tubes parallel btw, its a simple change

[majinb]

Vapourbot Images...

http://i74.photobucket.com/albums/i268/_MadBull_/isolation.jpghttp://i74.photobucket.com/albums/i2.../isolation.jpg

[joey_picus]

Vapourbot Images...

Extremely wooty Marti, thanks for doing it.

[kodster]

Vapourbot Images...

I should thank Martijn for taking that load of stress off my mind. Thanks.

[joey_picus]

Vapourbot Images...

Yeah, sorry for causing all that.