Pneumatic cylinder holes

[limpet]

I`ve just got an SMC compact cylinder http://www.ebay.co.uk/itm/1808235949...84.m1439.l2649
and looking inside the input/output holes are just 2mm, should I drill them out or will it be enough?

[jonny]

Re: Pneumatic cylinder holes

Drill'em out

[limpet]

Re: Pneumatic cylinder holes

ok biggest one I can find

[woody]

Re: Pneumatic cylinder holes

Could be NO.

You must check on the position of the piston in relation to the hole when retracted ... as I recall the type you have drops almost to the edge of the 2mm hole ..

[woody]

Re: Pneumatic cylinder holes

Not the best pic ...but it'll do.

http://www.smcpneumatics.com/pdfs/smc/cdq2bp.pdf
page 5


This is better!....[attachment=0:2fcw7lkn]cdq.jpg[/attachment:2fcw7lkn] The answer is now NO!

Your also loosing a fair bit of stroke with the magnet activation additional part of the piston.

[limpet]

Re: Pneumatic cylinder holes

bugger. will have a look as soon as I can find some decent tools to get it apart!
thanks

[limpet]

Re: Pneumatic cylinder holes

ok its been dismantled...
I don`t think it can be drilled enough to make it effective and I can`t test it without some different threaded connectors (might be USA spec?) so I`ve bought a similar sized Festo and rearranged the insides of my robot to accomodate.
It`ll be back on ebay along with a couple of other bits I don`t need now.