Tweet
Testing hornet 2s disc today and all was well. I got through a battery pack on the first test, waited until they cooled down and charged them again.
On the next test with a fully charge set of batteries, I inserted the link and the bot suddenly started spinning on the spot outwith my control. I made a grab for the link and tried again. Second time the magic smoke came out the sabretooth (seemed to be from the underside of the board).
I am running 2 18v drill motors on 24v.
Anyone had similar problems or know how much a repair might be? This is the only the first time I have properly used the controller after switching from electronize.
On the next test with a fully charge set of batteries, I inserted the link and the bot suddenly started spinning on the spot outwith my control. I made a grab for the link and tried again. Second time the magic smoke came out the sabretooth (seemed to be from the underside of the board).
I am running 2 18v drill motors on 24v.
Anyone had similar problems or know how much a repair might be? This is the only the first time I have properly used the controller after switching from electronize.
Comment