Tweet
Tips for drilling metal
HAHAHA gary i looked at your post neat top about holding your material as a time saver i remember when i did that nearly lost my fingers, the drill bit grabbed and it pulled my hand slamming it against the vice with my fingers between the bit of plate i was drilling and the vice lucky for me the drill wasnt in the chuck very tight so the bit just spun in the chuck, left me with sum nasty cuts but i would have lost my fingers for sure if i had tightened the drill bit properly.
HAHAHA gary i looked at your post neat top about holding your material as a time saver i remember when i did that nearly lost my fingers, the drill bit grabbed and it pulled my hand slamming it against the vice with my fingers between the bit of plate i was drilling and the vice lucky for me the drill wasnt in the chuck very tight so the bit just spun in the chuck, left me with sum nasty cuts but i would have lost my fingers for sure if i had tightened the drill bit properly.
Comment