Bulldog Breed

[mattsdragons]

Re: Bulldog Breed

ORDERING A NEW PLUG SEEMED TOO DO THE TRICK, BULLDOGS ALIVE!

Though fowards and back are left and right on one stick and left and right are the same, but on the other stick... I think I can live with that

[psycho_fling]

Re: Bulldog Breed

thats to do with the channels the rc plugs from the controller are plugged into on your reciever easy fix

[mattsdragons]

Re: Bulldog Breed

Not quite sure what too do as I tried that, it either didnt work or didnt failsafe

Got it working on one stick but still with left and right being forward and back, is it worth swapping the + and - round on the servo leads

[razerdave]

Re: Bulldog Breed

Do NOT do that under any circumstance!

If the up and down turns left and right, then either it's plugged in the wrong channel or one motor is wired the wrong way. Drop me a FB message later and I'll talk you through it.

[Mouldy]

Re: Bulldog Breed

Not quite sure what too do as I tried that, it either didnt work or didnt failsafe

Get it in the configuration so it works and doesnt failsafe.... then re-set the failsafe positions....not hard.

[beast]

Re: Bulldog Breed

[/quote]

Get it in the configuration so it works and doesnt failsafe.... then re-set the failsafe positions....not hard.[/quote]
rebind then (reset dave said )

[mattsdragons]

Re: Bulldog Breed

Tided the wiring up yesterday, shortened a lot of it so its not all hanging there

2 jobs left are replace the powerlight as I blew that so bulldogs light will now be red and sort out turning as left is right and right is left, but got 2 months too sort it

Off too the glade arena in Kidderminster tomorrow but not for robots, day at a reptile expo

[psycho_fling]

Re: Bulldog Breed

can i reccommend that you move the power light from your gas/link panel as at Guilford i remember that causing a few problems

[razerdave]

Re: Bulldog Breed

For steering it should be a case of flipping the channel (not sure what TX you're using).

[mattsdragons]

Re: Bulldog Breed

I shall be re-locating the light probably too the back panel since it did cause some issue

[mattsdragons]

Re: Bulldog Breed

Got the drive working well but as with everything, a new problem comes about

When trying too fire my flipper, the 'Up' valve gets hot quite quick yet the repay inside doesnt respond and click, tried replacing the main valve head (black cuboid thing) and it still does it

any ideas?

[Mouldy]

Re: Bulldog Breed

Your valve is staying on... When you fire it your turning it off.... Get a multimeter.... And test it.

Youve probably reversed the channel on your rc by mistake...

[mattsdragons]

Re: Bulldog Breed

I may well have done as I was flicking them about yesterday but must have hit the valve channel by mistake

[mattsdragons]

Re: Bulldog Breed

Now with a whole new control system for the flipper, bulldog is coming back barking

[mattsdragons]

Re: Bulldog Breed

New ram just arrived, new batteries and a suprise, see you at whitwick